C220 M4 Boot iSCSI Target from embedded NICs

[Daniel Andryszak]

I have a C220 M4 that I attempted to boot from an ISCSI target from the embedded Ethernet ports.

I can add the IQN with no issue.

When a try to “Add an Attempt, I receive the following message.

I checked the Network Stack – it is enabled, but I’m not sure if other options need to be changed.

I have booted from an iSCSI target using the MLOM 1227 and configuring iSCSI vNICs for boot, but not directly from the physical NICs.

Has anyone had access booting from this configuration?

[Kirk J]

Just a guess, but I seems like Intel NICs had the PXE option rom show up/get preference vs the iSCSI one.

I think there was some sort of intel utility to change which one was the active (PXE is default).

Kirk...

[Daniel Andryszak]

Kirk,

Thank you. I will try that and post the results.