Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a WLC5508 with around 70 AP's (LAP1042N) connecting over an MPLS WAN network.WLC and AP's are running 7.4.100From time to time I have an AP which disassociates from the WLC with the logging beneath.Can anybody tell me if this is a problem w...
Hi,I would like to implement NAC (802.1x) in my network, but I have a lot of loose unmanaged switches lying around.Are there any 8021.x enabled desktop switches (4 ports or 8 ports) ?Thanks,Tom
Hi,I have a WLC 5008 running with 40 AIR-LAP1042N-E-K9 and country code BE (Belgium) configured.I also have some AIR-AP1142N-C-K9 which I converted to CAPWAP OS.Unfortunattely only 1 of the 2 radio interfaces is working because of regulatory reasons....
Hi,We have a MPLS network to interconnect our remote offices with our datacenters.On the remote offices we use C1841 routers with ios c1841-broadband-mz.124-25d.bin.The lan interface is a dot1q trunk with 3 subinterfaces (and so 3 subnets)Recently we...
Hi,I have a question about RIP routing:I have 2 routers (A and B) connected to each other via an ATM wan link.Each router has several routes in his routingtable. For example: router A has a route to 10.0.0.0/16, 10.0.1.0/24, 10.0.2.0/24,...Router A h...
Hi Tarik,I mean, are there models existing I can buy ?I have only linksys unmanaged switches, but I would like to replace them with small DOT1X enabled devices ...thxtom
Hi,I solved my problem.Had to disable all the radio interfaces again on the controller, then change the AP's from country code, then reactivate everything again ...Very user friendly
Hi Nicolas,Thx for the answer.To activate the counry codes for BE and China, I first had to disable all B-g-n networks (meaning all radio interfaces).Now the 2 country codes are activated, but I can't switch an AP's country code.(advanced tab -> co...
Hi Mani,Very strange, i've put the explicit 'ip split-horizon' command on the ATM0/0/0.1 interface and removed the inbound distributelist.Since 2 days no issues ...The thing is that i've never configured the 'no ip split-horizon' command somewhere .....
