About ShaunGreen

ShaunGreen · 10-21-2021

Hi All,Using Cisco DNA for PNP.I wonder if anyone can help me out. I have a seed device which is configured as so:pnp startup-vlan 60 And the interface that the pnp device connects to is configured as a trunk.The pnp device picks up an IP from the DH...

ShaunGreen · 07-14-2021

Has anyone any experience of the following?Currently there are two ISE standalone servers being used for Tacacs for SSH access to switches.The plan will be to install 3 new PSN's distributed globally and configure 802.1x NAC.Is it possible to use the...

ShaunGreen · 01-04-2021

Dear All,I'd like to run the following past you to see if anyone is able to shed more light on the subject.We've noticed that when a show running-config is issued against a non L type 9300 (although it's running 16.9.5) the ACL's are in an output for...

ShaunGreen · 11-12-2020

Hi All, Apologies if this is the incorrect forum, I couldn't really find anything more suitable. We are starting to test configuration of of 9300 switches using RESTCONF. In the reports of the ISE TACACs server I can see the logs for Authentication a...

ShaunGreen · 11-11-2020

Apologies if it's been asked before, but I've search and can't find anything suitable. Also, I'm very new to Rest Conf, so please bear with me I've managed to pull in the switch interface config using the following: GET https://{{host}}:{{port}}/res...

ShaunGreen · 10-22-2021

I got too caught up in the nitty gritty!! I was trying to find a way to NOT configure the switchport allowed vlan command, but you are right. The most straight forward way is to just over write it when we claim the device.Thanks.

ShaunGreen · 07-14-2021

Thanks for the advice Mike, appreciate it.We are only talking about 3000 end points (for Radius) Network device a couple of hundred, but they are geographically separated.Yep, currently the existing two devices are doing the T+ and Radius for wifi gu...

ShaunGreen · 01-04-2021

Sure, hope this helps. show running config with 9300 L Show running-config with 9300 NON L

ShaunGreen · 11-12-2020

Thank you, I shall work through this in a lab and report back how I get on.

ShaunGreen · 11-05-2020

Hi @Massimo Baschieri ,Sorry my ISE skills aren't fantastic, I'm still building my knowledge up, could you please provide a few more details with regard to adding the probe-on option?

Member Since	‎10-11-2004 03:12 AM
Date Last Visited	‎04-12-2022 12:25 AM
Posts	75
Total Helpful Votes Received	20

User Statistics

User Activity

Plug and Play Allowed Vlans

ISE - PAN's for Tacacs PSN's for Radius

IP ACL Numbering on 9300 L

AAA Accounting for RESTCONF connections

Deleting multiple parts of interface configuration using Rest Conf

Re: Plug and Play Allowed Vlans

Re: ISE - PAN's for Tacacs PSN's for Radius

Re: IP ACL Numbering on 9300 L

Re: Deleting multiple parts of interface configuration using Rest Conf

Re: Ignoring Logged Messages in Radius Live logs for test user