Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to configure our router to be both an NTP client and server for clients on our network. I believe that I'm running into a bug. My configuration is: access-list 1 remark Restrict NTP to local networksaccess-list 1 permit 207.x.y.0 0.0.15.2...
The following issue in question occurs after-hours. I cannot test normal hours at the moment, but I assume the schedule is not the issue. I'm hoping someone can explain why the following may occur.Background:We have a UC System Call Handler configu...
We currently run (2) 7206-VXR w/NPE-G1 as our edge routers and (2) Catalyst 3750G's as our core L3 switches. Our entire network only pushes 50-100 Mbps at the moment. We want to go with a 100% hardware based platform for IPv4 and IPv6 and give ours...
I'm trying to configure an IAD2431 to register to CUCM 6.1 using MGCP. I have entered all of the MGCP commands and enabled 'mgcpapp' on the voice ports. I configured the gateway in CUCM as well, but it's not registering. I confirmed that the hostn...
We have a Catalyst 3560G 24 port POE switch. It's been running fine for 1+ years. A few weeks ago we enabled SPAN on it to capture packets. Today, we had a random spike in CPU on the switch. Seems hardware swithing continued to work fine, but sof...
Was this issue ever resolved? Still seeing it on Android 4.4.4. Jabber Voice is registering to CUCM using the IP address of the phone's WIFI interface rather than the IP assigned by the AnyConnect client. This causes one-way audio and prevents the...
No, "Mark Message for Dispatch Delivery" is not checked under the call handler Message Settings. Also, under the Distribution List, the only fields populated are:AliasDisplay NamePartition (same partition as the call handler)Replicate to Remote Site...
Thank you. That was the issue - the digit-by-digit collection was matching the voip dial-peer before the 9T POTS dial-peer. I ended up fixing this by implementing cor lists so that:1) Incoming PSTN calls can only use the dial-peers to CUCM and the ...
