Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There are two physical servers behind the load balancer. These servers arein VLAN54SRV212 - 205.190.54.212SRV213 - 205.190.54.213Load Balancer VIP for the above servers - 204.190.54.67Load balancer keep alive port - TCP 9999Load Balancer VLAN54 IPa...
HiCan some one tell me which ONS product i should use to interface with an SDH network (STM 4) and can interface with a Fiber channel switch.RegardsChampika
Hi AllDoes anybody know why the IOS FW is not allowing the return traffic on a subinterface of a 7200 router.7200 is running 12.2(15)T10Appreciate your help. CheersChampika
Hi I have a STM1 interface on my 6509 and the interface is multi mode. I want to connnect to the service provider transmission equipment but their equipment supports only STM1 on Single mode. Have you guys seen a situation where once side is Single m...
HiI have a customer who is looking to position the GSS4491 for site to site Load balancing. The main site is connected to the internet via two 2811 routers with 2 1mb internet leasd lines.The firewalls are just behind the routers. My question is wher...
The IP inspect is in the inbound direction to the LAN interface & the Access-group is applied outbound to the LAN interface.For ex.int fa0/0.1ip access-group fa0:0out outip inspect fa0-0 inThis is my setup.But the traffic going out of my router to th...
HiI have a single VWIC-1MFT-E1 card with a AIM. I have done the followingnetwork-clock-participate wic 0network-clock-select 1 E1 0/0This is to synchronize the clock received from the line to that of the AIM card. Now I have the following problem. Th...
Hi Carlo & MushtaqThanks for your replies. I will try the same. My routers have to be upgraded to support the CDP over ATM feature. Will test it after that.CheersChampika
Hi marcabalI have a similar problem. My sensor is running 4.1.3 (s66) and I want to appply the SP update for 4.1.4 which is IDS-K9-sp-4.1-4-S91.rpm.pkg. When i try to update from the IDS MC i get an error.object error. The file may be corrupt or unab...
