Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 8 port Dialogic PIMG box set up with our CUC 7.1. The MWIs are very flakey where CUC will try 4-6 times to turn the MWI on/off. It seems to trigger after the 1st attempt, but it keeps trying which ties up the port for a little bit. Has an...
I have CUCMBE 7.X installed in a quad core 2.4Ghz system with 8Gb RAM. When Unity is playing prompts or messages, the audio occasionally "blips" or "hiccups". Is this inherant to a VMWare install? Or have people running CUC on VMWare had clean aud...
I have to import about 600 mailboxes with BAT and each of these has 2-3 pagers that need to escalate from one to another. Is there any way to import them all with the BAT .csv? The docs don't really specify anything beyond Pager1. Would I just use ...
On the UC540 platform, how exactly is licensing done? If you get a 8 phone license on the defualt kit, my understanding is that this gives you 8 IP phones, 2 teleworker phones, and 4 FXS ports. So you can technically have 10 IP phones along with 4 ...
Changed the IP of a CCM7.1 box. All the default media objects (CFB, ANN, etc) are still the old IP and cannot be adjusted. Is there any way to clean this up or do you just have to deal with the old IPs after an IP change?Thanks
You can look at the sticker on the back of the phones, if it shows V14, V15 or higher then it's safe to assume that it needs the later firmware. I had phones that had the 9.3.1SR1+ sticker on them that wouldn't take the SR1 or SR2 firmware. With SR4 ...
Cisco released a new statement with the 9.3(1)SR4 fw: Cisco IP Phones 7942, 7962, and 7975 manufactured with hardware versions as mentioned in the table above must run Firmware Release 9.3(1)SR1 or later. The phone firmware does not allow the phone t...
I just had a similar issue with a 7965 that had V14 on the sticker and was a v13 hw. The phone had changed clusters where it had been running SCCP45.9-3-1SR4-1S and was trying to downgrade to SCCP45.9-3-1SR2-1S. The advisory for the new hw revisions ...
Unity Conn definitely doesn't recognize the altered .CSV headers. Also, the export doesn't contain anything other than the default system notification devices. I don't see any option other than manually entering in the Pager2 info. Pager2 can be i...
