Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all
I am trying to deploy a new eap chaining authentication for machine and user authentication with certificate.
Tunnel EAP_FAST and authentication EAP_TLS
I would like to perform 4 policies:
Machine and user has the certificate: It is worki...
I am trying to deploy the EAP chain authentication with user and machine certificate. User credentials are ok, but the machine credentials are wrong. NAM - Editor - Anyconnect configuration: Machine credential: Protected Identity Pattern: host/...
Hi allI'm trying to use Anyconnect 3 as a 802.1x supplicant. Anyconnect - machine authentication with certificate is working fine. When I tryed to configure user authentication with certificate i have the follow message:"No valid certificates availab...
Hi allWe have a Wireless Lan Controller 5508 with software 7.6.130We have 22 Access Points 3600 with 802.11ac module In WLC monitor > Clients Clients 802.11ac are connected to 802.11acClients 802.11g are connected to 802.11b Do you see this issue ? ...
I am trying to deploy a wlc 2504 with a Radius Server of Windows 2012WLC: 2504 software: 7.5 The client wireless is facing authentication failure,Radius Server has the bellow log:ReasonCode 22Reason The client could not be authenticated because the E...
Hi Prabhu
I have an issue trying eap chaining for machine and user authentication with certificate (tunnel EAP_fast with EAP_tls authentication):
When machine and user not have certificate, anyconnect is trying EAP PEAP.
11001
Received RADIUS Ac...
Hi all,
anyone solved it ? I have a similar issue with ISE 1.4
I am trying to deploy EAP_chaining with user and machine certificate. (anyconnect 3.1.11004)
If the user has the certificate all is working fine, but if the user not have it, I can s...
Hi,
Do you solved it ?
I have a similar issue on eap_chaining with user and machine authentication.
When the user has the certificate all works fine, but if the user not have it, I can see a very large latency and the Endpoint abandoned EAP session....
Hi all,
I have a similar issue. I have a new deployment with eap_chaining_tls. Anyconnection is configured for machine and user authentication:
eap_tunnel = eap_fast and eap_authentication = eap_tls
If I have the certificates, all is working fin...
Hi Robert,I tried to configure the machine authentication with EAP_TLS and it works. I can see host/machinename.domain When I tried the authentication with EAP_CHAIN (tunnel EAP Fast + Authentication EAP_TLS) it is not working properly. ...
