Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We recently installed a 9606r for a campus core and we have had some troubling issue with devices falling off/dropping traffic.We have a few line cards 9600-lc-48YL for Copper SFP's. These line cards are heavily populated (all 48 slots used) an...
I am having a bit of trouble grasping something regarding Certificate authentication with ISE.In our current deployment we have imported our Cert chain signed by our Root CA into Trusted certificates store.We have setup our wireless authentication pr...
I have a scenario where we use ISE for EAP-TLS cert based authentication for wireless network. It has been working at our HQ for several months. Now we are trying to roll this out to our remote offices that connect to HQ over private WAN links.The is...
There is a listing for 5525-x ASA under product comatability for 10Gig module....I cannot find any documentation that shows the 5525-x support 10gig anything other then this listing. The spec sheet on the 5525-x don't come close to 10gig throughput e...
We use MAB for our port security with our switches pointed to ISE for the MAC database check. What is happening is that when we have:"authentication host-mode multi-auth" on the switchport and we unplug the uplink to simulate an ISE outage or WAN lin...
17.8.1r(FC1) and the line cards are showing 17.12.04The line cards are typically full, 48 slots used, we had the issue on different slots (slot 1 line card and slot 6 line card)The 2nd 9606r that doesn't have the issue is on :17.31r (FC2) with line ...
That was the problem, one of those famous "undocumented features". The reason it doesn't affect the entire network is because we are using WLC in our main HQ LAN. We are only using autonomous WAP in our branch locations. The command was already on th...
I am pretty sure its this:https://bst.cisco.com/bugsearch/bug/CSCuf16911I am waiting to do some testing to confirm. I noticed the successful WAP has that command on it, the one failing does not.
