Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi
I have a problem with two asa 5545 connected failover, I generate a tunnel ipsec to asa1 (active) and it works correctly, but when the interface outside of asa1 is down, the asa 2 becomes active but the ipsec.tunnel dont goes upi m...
Hi
my customer migrated their wan from clear channel to mpls network, they have HP DTC this works on layer 2, and i need to bridging traffic over mpls. With the clear channel there´s no problem, but with the mpls link is not working.
¿anyone knows ho...
hi alli have two catalyst 6509 in vss mode, but i have an issue, when the the active chassis goes down the standby becomes active without problem but the proccess cpu increases 28% the process that increases is this 22.79% 23.08% 14.67% 0 LTL MGR b...
hi i have an mpls nework with equipment cisco 2821, 2901 and 2801, and i have problems with fax calls, i configured the fax protocol t38 in all routers but when i want to send a fax to the 2821 equipment from either 2801 and 2901, the protocol t38 is...
hi Torbjørn
almost it works... my timezone is UTC-06:00. I configure it, but the schedule graphs show 1 hour less, looks like if the summer time were enabled, is there a way to disable it?
Hi Ajay
the failover happen without problem when the outside interface goes down, but the tunnel stays down
here´s the ouptup
ASA-VPN/act# sh running-config monitor-interface ASA-VPN/act# sh running-config all monitor-interface monitor-interface ou...
hithis is the configuration on the 2821:voice service voip fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback ciscodial-peer voice 10037 voipdescription CONEXION CELAYA DISTRITO XVdestination-pattern 561.session target ipv4:172.16.200.37incom...
hi Giuseppe, thanks for your helpi try removing the line neighbor 201.129.78.245 route-map local in and it works.... but this router-map set a weigh of 32770 to the prefix 1.1.0.0/16 when is received, so this way the router put it in the routing tabl...
