Hey Guys,I have an E1 r2 digital configured with only 10 channels.Although i have 30 channels configured on the PSTN side i could only configure 10 channels due DSP resource not being avaliable for transcoding and conference at the same time.So, my q...

Hey guys, I'm wondering if someone can give a help on this issue. I have a CISCO 2921 with a TDM interface E1 connecting using r2-digital to the PSTN provider. I can receive calls successfuly but when i try to place calls i'm receving the following e...

Hey Guys,would like your help because i would like to check why i'm receiving this error.When i try to place a call over a gateway that has a fractional E1 (10 channels only) i'm receiving the following output on "debug vpm signal".Apr  8 19:06:36 UT...

Guys,Need to know about how to remove properly a gateway MGCP interface so that i can use DSP resources to bring up conference at the site.I have the following MGCP gateways defined as the pics in annex.I would like to :1. Enter the interface 0/1/0.2...