Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a kind of complicate network design, where i got 6 locations which have internet connection with the same ISP with same AS number, where every location have own router and advertises a set of IP addresses by BGP.recently i get the 6 loca...
Hello,I have a situation like this:1x Core 6513 Switch.4x 3550-12T Switches.All 3550 switches are connected to the 6513 core switch, with one connection each (1Gbps).Now I need to transfer multicast and unicast between the switches.I'm sending intern...
Hello,I have a cisco switches 6500, 3500 & 3750.I'm sending multicast & reciving another multicast from 3750 switch on 6500 switch. And transfer it from 6500 to 3500 switch.now i want to stop the multicast comming from 3750 to 6500. is that possible?...
Hello,I just made a multicast on my cisco 6500 switch, and making transport to another location via trunk. so i made a vlan with set of ip's 192.168.222.0/24and transport the multicast to the other switch 2950.Now my switch 6500 is going to 100% cpu ...
Hello,I just read a lot of stuff about multicasting on cisco site. but didn't get the idea how to do what i need.So i have a multicast source at 224.2.2.2 and can watch it when i connect directly to the source.So i want to connect it to my core switc...
Well i had this issue fixed by changing the setup! it was wrong setup, so it's not just turn on the multicast routing and it will work.. IOS upgrade will not help with this issue.. already try it..you need to make a new setup..Regards
Thanks for your help, i did it and it works fine.All my locations now, can see the ISP and internet through the ISP, and the local network see's itself. i just used the same configuration for igp and it works ok. Regards.
So, you want to say that I can connect every location to my location #1 with same BGP paramters and same AS number? but on my location #1 I add this line?
Thank you for your reply.I just tried that, so i get the multicast to work, but my core switch CPU goes to 99%.Then i removed the ip pim-sparse-dense mode from the vlans, and turn ip igmp snooping on, and the cpu goes to 1% and the multicast works. b...
Yes, that works for me but the cpu utilization goes to 99% .. Let me explain.I'm recieving multicast on 238.0.0.1 and sending multicast at 239.0.0.1 and the multicast works fine. now i want to block the 238.0.0.1 multicast is comming to me. i...
