Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know if this file also contains the firmware needed for MX300 G2. The description says MX series but I want to make sure.
cmterm-ce8_3_1.k3.cop.sgn
Thanks
Planning on deploying an expressway core as a B2BUA gateway.
The deployment guide specifies that the UC domain is not the same as the MS domain. I'm trying to figure out if this solution could be implemented using the same domain.
If the change is m...
Has anyone ran into the following problem?The last shipment of 3602 APs for a customer came with 7.3 software. Controllers are running 7.2.110.0 so APs had to be downgraded. After APs finished downgrading they were still up. When we moved the APs to ...
Has anyone ran into this problem? I'm testing with a SIP9971 phone. In order to make PSTN calls we have to disable video on the device configuration page. When video is enabled, calls to landline work but no ringback. Local cell calls I get a busy si...
The following is the setup.WLC 4404 running 5.2.178.0 code. 1142N LAPs. ACS ver 3.2 is the radius server and is tied to AD.I tested with three different models of laptops, two worked and one did not. The first laptop that worked: IBM (not on domain) ...
We only have the log of the switch. The only message on the switch is that the power is denied. We do not have a log from the AP. We will capture an AP log next time we run into this situation. Once the APs were rebooted, they did not have a problem ...
No digit manipulation is done at UCM. Gateway is local, H323. I'm attaching debugs and dial-peer config. In this case the number is an LD number. It is matching the LD dial peer.Device pool is configured for G711 and G729. I also changed the phone to...
I changed the timers and I still get an authentication failure in the controller. The ACS says: EAP-FAST user was provisioned with new PAC.Does the ACS version matter?Thanks for your help!
