Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have recently upgraded two ASR1001s to a new IOS-XE version, and the "Major" LED light is on for both of them now.ASR-1#show facility-alarm statusSystem Totals Critical: 1 Major: 1 Minor: 0Source Severity Description [Ind...
Hello,I have an ISE appliance with the Wireless license. The Cisco vWLC is configured to send Radius traffic to the device, but is getting the error message:11054 Request from a non-wireless device was dropped due to installed Wireless licenseThe vW...
Hello,I'm currently in the process of setting up a new 5512-x to get it running with the context-aware module. I have read the documentation at:http://www.cisco.com/en/US/docs/security/asa/quick_start/cx/cx_qsg.htmlBut still have some questions about...
Greetings all,I'm going to be making a change to an existing client's network soon where multicast traffic is used over GRE (no IPSEC) tunnels. The client is adding a new location and is going to have a 10.x.x.x private IP space for the LAN side. The...
Hello,I'm in the process of setting up Anyconnect on the ASA, and have successfully updated the licensing, as well as uploaded the anyconnect pkg for web deployment. I enabled anyconnect on the outside interface and can now have the ASA push the clie...
Thanks, Lulian. I updated the ROMMON code to 15.3 but the boot LED still persists. I'm thinking you're right and this either a bug or a cosmetic issue. Going to close this out. Thanks.
Here is the previous IOS version as opposed to the new one:asr1001-universal.03.07.00.S.152-4.S.binThe only difference is that one of them is the K9 image and the other one isn't.Below is the output of "show platform". Again, the CRITICAL alarm goes ...
Great stuff. I was missing the "asdm image disk0:/asdm-647.bin" CLI command. I closed ASDM and relaunched and VOILA! Now the Anyconnect Client Profile is there! Thanks again, that saved some serious headaches.
Thanks for the help! Per your advice, I used the standalone Profile Editor and exported the subsequent XML file to the ASA. This worked just as you suggested. I tried the upgrade to 6.4 ASDM, but it still wants to use version 6.2 when I connect to th...
Thanks for the response Marvin,It shows the ASA and ASDM versions are 8.2 and 6.2 respectively.Result of the command: "sh version"Cisco Adaptive Security Appliance Software Version 8.2(1) Device Manager Version 6.2(1)Result of the command: "sh act | ...
