Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good dayI have a problem, my cucm has 73 registered model 6921 IP phones, but 12 model 6921 IP phones that do not register.
I have reset the Network and Security option; I also went back to delete it from the CUCM and returned it manually, but it st...
I have a "UCS C220 M3" without hard disk, only with SD Memory 16Gigas (with the base operating system). Additionally I have a Storage IBM.How I can map the IBM STORAGE the "UCS" to install my VMWare (cisco Prime)?Cisco UCS : have only ethernet portsS...
Hi Sirs.I have a CUCM 8.5 and ISR 2951 -> "SRST and Gateway on same device".I have phone "IP Communicator", "6921" and "7942" registered in CUCM 8.5, but when I turn off the CUCM, I see the "SRST" registering all phones, but only gives the DN to "69...
Hi friendsI trying to install a CUCM 8.6 2a in a UCS : C210M2 , but appears this error message:Critical Error:The hardware you are using is not supported for this product. Installation will now halt.What could be the problem?Roni
I installed LMS 4.0 succesfully, but when i go to topology, can view all network, but the "AswitchA" Core 4507R+E be displayed as "?" , and it can not display this "AswitchA" into CISCO VIEW, display this messaje :"Cannot find applicable device pack...
Checking, in the CUCM (Cisco Unified Serviceability), I see that the TFTP service is "active", but "not running". I try to start it, but it stays the same.
Hi JaimeI checked again and the configuration is in the CUCM. Several months ago these phones were registered, but they were disconnected and saved, now that we have reconnected them they do not register.
I checked again and the configuration is in the CUCM. Several months ago these phones were registered, but they were disconnected and saved, now that we have reconnected them they do not register.
