Hi team,I have a Call manager express router to which IP phones can register automatically. The event (%IPPHONE-6-REGISTER: ephone-2:SEP0022191D02C0 IP:149.77.175.201 Socket:3 DeviceType:Phone has registered) will be there in syslog. So, based on thi...
Hi team, We have purchased a Cisco 2921 router for Call manager express. For installing Cisco Unity express, we have installed an ISM-SRE-300-K9 module on the Cisco 2921 (motherboard). I have read Cisco documentation and some blogs regarding configur...
Hi team,I have recently configured a hunt pilot/hotline in Call manager. There is now a requirement to forward unanswered off-hours calls (calls between 6 PM IST and 9 AM IST) coming from a particular calling number to a mobile number. I am not sure ...
Hi team,We have just purchased a new Cisco 2921 router for Call manaegr express. The router has ISM-SRE-300-K9 module installed on Slot 0 for Cisco unity express. We have initially verified that the module status was fine yesterday. But after we rebo...
Hi team,I need help to admin disable the 802.11a radio interface from a few lightweight APs. The operational status of these radio interfaces is down, so I am getting the following error when I try to disable them from the wireless LAN controller.(Ci...
As the device is not detecting IM-SRE module, there is noting related to ISM. "service-module ism" itself is not working. It was working yesterday when the module was detected.cme2-test.mjv.shaw.net#service-module ? Embedded-Service-Engine cisco em...
Jesse,There is only 1 IOS file (c2900-universalk9-mz.SPA.151-4.M4.bin) on the router. So, the router booted with the correct image only. I have verified the link you have provided also.Regards,Suchitra
Hi Murali,I have worked around this issue by configuring in such a way that different outbound dial-peers will be selected for calls from IP 7000 and for other calls between CME and CUCM. The outbound dial-peer related to IP 7000 calls will have "cal...
