Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
I have just completed an upgrade of an FTD HA pair (2110) to ver 7.2.5. FMC is reporting that both Primary and Secondary HA failed. However, when I log into the cli, show high-availability confis shows Active and Standby Ready.
I can't fin...
Hello Community,
Whilst preparing for a 4110 FTD upgrade via FMC, the readiness check fails.The log files should be located here:Status Log:Readiness Check To x.x.x.x Failure Logs@ /ngfw/var/log/sf/Cisco_FTD_SSP_Patch-6.2.3.18/upgrade_readiness
The n...
Hi all,
I'm looking for documentation on how to migrate AP's from Converged Access back to CUWN.
I can find doc on migrating from CUWN to CA but not the other way around.
Regards
I’m trying to set up a VIC-4FXS/DID but to no avail. I’m trying to work out if I have a config issue or a faulty FXS card. I have tried the card in a 2801 and 2811 both with PVDM 2 64 DSP’s running CME 8.6 IOS C2801-ADVENTERPRISEK9-M), Version 15.1(4...
Hi all,I'm looking for documentation on how to move ISE 1.1.4 VM's in a distributed deployment to new hardware. I'm planning to move 4 servers for a client to UCS hardware but can't find any documentation for this. The closest I've found relates to v...
To fix this, I had to complete the post upgrade deploy operation on the primary, after which I was able to synchronize the secondary with the active FTD.
Update: The secondary is failing to synchronize. If I reboot the standby, it comes up and goes into synchronize state before returning to the failed state.
Thanks for the advice. If anyone struggles with the 4110 CLI, this is what I've discovered at least on the device in question...
via the console I get a cli <hostname>#. From there I can access the fxos cli by typing connect fxos: <hostname>#(fxos)
I...
Hi there,The client is a laptop running the vpn client, so you were spot on when you suggested NAT exempt.Basically I got this working by changing the nat rule as follows:removing:ip nat inside source list 1 interface Dialer0 overloadand adding:ip ac...
