Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community, We are trying to subscribe to a certain event (AP disconnected from WLC). We would like to send a syslog event to a third party monitoring tool. Syslog or SNMP cannot be selected in the Subscription type drop down (see attach). Is th...
Hello Community,Hope you are all sound and safe!!As old CiscoWorks users, we are doing an in depth POC with Cisco DNA to manage our Cisco network.We are doing some tests with template editor/provisioning and encounter issues with input forms.There is...
Hello Cisco,We are struggling integrating our Nokia 7750 SR with Tacacs+ ISE 2.4TiMOS-C-15.0.R7 cpm/hops64 Nokia 7750 SR Copyright (c) 2000-2018 Nokia.Does anyone has integration examples for this type of device? Kind regards,Lieven StubbeBelgian rai...
Dear Community,
We are doing a MAB POC as we speak to enhance our level of port security for exotic non-dot1x devices.
Our testdevice is a IE3000 8p industrial switch with Version 15.2(2)E4 (preferred IOS version for communication with ISE 2.2).
Wh...
Dear Community,
We are doing a MAB POC as we speak to enhance our level of port security for exotic non-dot1x devices.
Our testdevice is a IE3000 8p industrial switch with Version 15.2(2)E4 (preferred IOS version for communication with ISE 2.2).
Wh...
Indeed this is very annoying behaviour, but is seems that Cisco implemented this new "feature" in IOS 17.7 and later, so we don't have any choice I'm afraid :https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/17-7/releas...
Hello, We have the same issue on one of our C3650 PoE switches : after changing the conf-reg to 0x102 and rebooting several times, this switch still ignores the startup config and keeps saying "Configuration register is 0x142 (will be 0x102 at next r...
Hello Arne, Thx for the swift reply, the problems we have are multiple, when entering 1 command manually it seems to work, but in ISE there are multiple entries (3). When entering a block of commands several commands are executed (also 3 times), then...
We are running IE3000 8p industrial switch with Version 15.2(2)E4 (preferred IOS version for communication with ISE 2.2), if we can't even trust preferred Cisco versions anymore?
Excerpt from the Cisco doc: "During the MAC address learning stage, th...
We ran a packet capture and saw that the device had a fix Ip
The moment we changed it to DHCP, MAB works.
When we reconnect the cable, a DHCP discover is send out, and the MAC is learned by the switch, which can be used for MAB procedure.
