Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In an SD-Access multi-site deployment with 10G metro-ethernet between sites can a shared PSN pair be used across all sites (hosted at DC) or do we need to dedicate a PSN pair per fabric site? All documents seem to point to dedicated PSN per fabric si...
I'm currently working on a HLD for 3-site SDA design and need advice on L2 Handoff please.Can multiple VLANs be configured at the same Border or is it single VLAN support only? Appears to be no documentation anywhere that references multiple VLAN des...
Regarding the sizing of an SD-Access Transit Control Plane node, will a pair of Cisco 9300 switches be sufficient for a 3-site design (hospitals) where there would be anywhere between 4000 and 6000 active endpoints per site at any one time and approx...
Can anyone confirm if the 9332C ACI spine switches support connection to IPNs using the two on-board 10G SFP+ interfaces?Anyone had any experience setting this up? Can't seem to find any validated info on this except for using QSA breakout cables on ...
Can anyone confirm if an external hardware Grandmaster Clock is mandatory in all Multi-Pod deployments, or only when PTP is enabled/required?I have a customer wishing to use ACI as a pure L2/L3 underlay for NSX between 3 campus comms rooms and they d...
Hi @dagraham:
How did you set up the ODBC connection below? Similar to a wallboard and uccxhruser setup, I'm guessing? But how did you reference this via the PowerBI ODBC connector as I cannot get it working?
"On a windows server / workstation, we ...