Hello All, Trying to set up Site to Site VPN using 3825 to 2801I am a complete noob to VPN. I have some understanding of Networking and Switching (CCENT) I am trying to set up a Site-to-Site VPN connection from one testbed gateway to another within a...

Is there a way I can set a timer so that CLI does not log out? I'm running CUCM 6.1 Reason being is that everyime CLI logs out, I lose network connectivity. But as soon as I log back in, I am able to console into CUCM. Would setting the CLI to not lo...

I have a router configured with the IP 1.2.51.3 onto g0/0. It does not show the switch when doing show cdp neighbor. I cannot ping gateway, switch or TFTP server. Cables have been replaced. Interface has been brought up. This issue was seen before bu...

I have an engineer who's requiring me to assign a NAT inside address to a CUCM. Eth0 on this CUCM has been configured to a drop for outside access. I am trying to configure the NAT to eth1 but it does not appear within the CUCM. It is enabled in BIOS...