Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I'm having some difficulties configuring our 2801 acting as CUBE to work with our new VOIP provider. Everything worked perfectly with our previous provider TDC, but for a number of reasons we had to change and we choose CellIP as our new provider....
Hi.I's suppose to setup i IPSec tunnel between an 1811 and some sort of CheckPoint firewall. The IPSec part isen't that big of a deal, but the system manager on the "CheckPoint side" want the traffic though the tunnel should originate from a public I...
I wanted to add PoE option to one of my ISR 897 VAM routers. So after googling and looking though all the documentation the datasheet for the 890 series router i ordered the 800-IL-PM-4. After installation of the daughter card I realised that to get ...
Hi.I have a question that I have been googling a bit, but I can't seem to find the awnser to, and it may well be that it's not possible.Lets say that I have remote site with two networks, in this example called Vlan 10 and Vlan 20. I also have a cent...
Hi.I'm having difficulty getting a router/L2L VPN scenario to work. I'm not quite sure that it's possible to do what I want to do, but after reading up on OSPF all day I don't see why.Site A:ISP has a 1812 router that have two interfaces at my servic...
That did the trick!! Thanks alot!I tested a bit by adding the lines back, and when adding backl the "voice class sip profile" it stopped working again.The reason I set that up was because I tryed to mimik the invites I recived from the ITSP. Is there...
Here is my current running configuration plus a more cleaned up log-file from x-lite. Something seems to have gone wrong with the CR.Best regards,Johan Christensson
I actually found a log function in the application. I filtered out the SIP bits. Here you can clearly see that x-lite is sending an INVITE with an authentication header after the first "401" message, just as you stated earlier.So, the question is why...
