Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have cube configurations we inherited that we can see the dial-peers are pointing to:
session target sip-server
Normally you would have defined sip-server in the sip-ua area, but it's not showing there at all.
I'm assuming it's defined some ot...
I've got a client running Unity Connection 10.5(1) and integrating single inbox to Exchange 2007 SP2. If a voicemail is left it appears in the Exchange inbox right away and the MWI is lit. If the user changes the status of the message within Exchan...
Just upgraded an 8.5(1) CUCM to 10.5(1) and now seeing SOAP-CallRecord Service restart every 10 minutes. Anyone have any idea what might be causing it? DB replication appears to be good. User's aren't reporting any calling difficulties.
I have a client who is reporting that Jabber for windows 9.6 is sometimes losing the sign-in credentials even though they checked the box to save them. Has anyone seen this behavior and determined a cause?
I have a customer with a CUEAC 9.x installation and they are able to park calls and transfer calls mostly without issue, however, when the operator parks calls, and the call is not picked up, the call is not reverting to the operator. The call stays...
That's what I thought too, but this doesn't seem to be the case (no voice-class tenant or voice-class sip tenant commands anywhere). It seems to be related to DNS and host entries, but I don't see anything tying them specifically to the sip-server ...
You are correct - I wasn't clear. There are sections in the configuration guide about mult-tenants and VRF aware DNS (separate sections, but both in the guide). I was simply trying to say I looked at both sections and neither seemed to apply. I w...
That doesn't appear to be the case. I see in the CUBE configuration guide a discussion of multi-tenant and VRF and the dial peer config does look similar, but there is no ip host vrf references or interface references or anything like that that woul...
Thanks for the response. Although best practices say to use hardware, I don't believe the setup I am seeing here is unusual, especailly is the total number of users isn't anywhere near the CUCM capacity (they have 1 pub and 2 subscribers and they ar...
