Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
IOS-XE Update Failure (Catalyst Center)We are trying to update the equipment, running in install mode, and it fails deployment due to lack of space. The command: [ install remove inactive ] does not correct the problem. Is there a document that lists...
Using:Cisco Catalyst CenterVersion 2.3.7.7-70047 Several sub-packages including Access Control, AI Analytics, et al. Issue:There appears to be a limit on recurring discoveries. From what I can see, I cannot have more than five scheduled. Goal:I am tr...
Hardware:
WS-C2960S-48LPS-L 15.2(1)E PoE+
WAP581-A-K9 V01 1.0.0.7
I've tried setting up both links on the AP. Chose the setting of "Standard LAG" on the AP. The AP says it does not support LACP in the docs. I had already setup the port-channel b...
Hello,
We currently are using Cisco Prime Infrastructure 2.1 (2.1.0.0.87) and have multiple site locations that are "shared" such as office buildings. Due to this we have a rogue report going over 2000 pages, and I am looking to cut that down by eli...
Using Prime Infrastructure 2.1 is it possible to generate a report across multiple switches for the ports that are configured to use dot1x and those that are not? The goal of the report is to identify the percentage of ports currently using dot1x vs ...
This, incidentally, is the probable solution. I was a bit dense as I'm used to using LACP for Port-Channels, since it is the recommended method. The config on a 2960S, where X's are your Port-Channel and Y's are your interface numbers:
interface Po...
