Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
We have 9606 running active-standby and each box has 2 supervisor 1. Currently running version 17.2.1 and planning to upgrade to latest 17.9.5.
I know that complete reboot using install command would be the best, however we would like to mi...
Hi guys,Need your help on below situation.I would like to configure the netflow on the FTD. FMC is running on 6.4. I created new flexconfig object and defined the destination. Created new flexconfig policy and assign the firewall accordingly. These ...
Hi guys
the plan is to upgrade nexus sup1 from 6.2.8 to 6.2.16.
i have run the install command as per below and it looks i can do direct upgrade.
The result is good there is no incompatibility issue
Compatibility check is done:Module bootable ...
Hi Guys, need your advice. We have installed the MPA A9K-MPA-8X10GE to the line card and try multiple commands but failed to bring that up. However if we we reset the line card and it works. We understand as per spec this card is supporting OIR. The ...
Hi guys,i woulld to perform IOS upgrade on ASR1002RP1 to ver adventerprisek9.03.09.02.S.153-2.S2. I will also upgrade on rommon but just like to confirm if anyone can help on:1. do i need to perform by babystep upgrade (current version is adventerpri...
Hi Thanks for reply.>From the Cisco note, it mentioned I can use other interface. If I use other interface, is the MANAGEMENT name is the mandatory to be used for that interface?Would it not work if using another interface?Note:Alternatively, a diffe...
