Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a VSAN that span across two sites and we want to split it so we keep the original VSAN (44) in site one but in site two create a new VSAN (88) and make the members of the old VAN members of the new. We use Basic Zones. I see the steps as foll...
I setup Radius on our 9509's and it did work fine and for no reason it has stopped working (nothing changed). It still works via CLI but not via Fabric & Device Manager (DCNM), just get "Unknown User or Password". Running 5.2(2)I have removed Radius ...
I'm trying to setup LDAP Authentication for our MDS 9509's running 5.2(2) without success, I followed the "Sec Version 5" document. When I try to login and run "Debug ldap all" (on another session) to capture what is happening I get success for most ...
After we upgraded from 3.3(1c) to 5.2(2) our Call Home has stopped sending emails when any host logs out/into any of the switches. Nothing else has changed, the same profles exist with the same “MsgLevel” settings. In the release notes for 4.2(1b) it...
We are carrying out a firmware upgrade on our 9509’s from 3.3(1c) to 5.2(2) and I want to know if the steps below are correct?Check hosts for paths to both Fabric's.Take a backup of the config for all the switches.On Fabric A upgrade switch 1 to 4.1(...
I have set this up but on MDS switches. Things I can think of.Do you have a Firewall between the server and the switches, Ports 1812 & 1813 not been passed?Do you have ACL on the switches?What is your Radius setup?What Authentication are you using e....
1) Yes we have a Storage Array in each site, we run Active/Passive so the hosts in the second site can be powered down2) Tape library is in another VSAN, so the servers only connect to the Storage Array3) Yes, we will do one fabric at a time. Yes, t...
I gave up on LDAP and went for Radius instead and had fun with that, I had to open a call with Cisco around password changing (see my other thread).Good luck with the LDAP authentication, let us know how it goes?
