Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok so I have troubleshooted E1 slips and errors multiple times before. I am aware that the issue is due to clocking. Heres my problem: I have configured to take clocking from E1 1/0 which is a telco PRI and this is working fine on E1 1/0 i.e no slips...
Hello - Tech in use: CUCM v8.6 and MGCP Gateways 3945's (x 2)I want to load balance SRST across two branch ISR routers, lets say GW01 and GW02. I will have 1 inbound PRI connected to each gateway and a DDi range will be load balanced across both PRIs...
Version of CUCM - 8.6Version of X-Lite - 4.5I have setup a Third Party SIP phone (advanced) to try to get an X-Lite client working but am running into difficulties. When i try to make a call out to the PSTN, I am just getting a fast busy tone - there...
Need to do a bulk import of tranlsation patterns but have never done this before and do not want to end up deleting any existing tp's. Do I need to export ALL the tp's then add the new tp's and then import all of them together again? Or do I just imp...
Hi - I would like to test SRST at a remote site using an access-list to block all traffic to back to the CUCM and force SRST at the site...The Voice Gateway is separate to the main WAN router so I propose to put the following access list on the uplin...
Thanks for the reply!I am running both the VG224 and the voice gateway on MGCP. So I beleive the incoming gateway is also running fax passthrough as the commands posted above are on both devices...Is there a way I can check if I am running fax passth...
Hi,The issue is with a IVR system that is not controlled by us and I dont know what technology it uses as its an external company. I just need to try to figure out if there is something on my end that I can tweak as the issue is intermittent.
