Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to pass layer 2 traffic across a layer 3 link between a Catalyst 4500 and Catalyst 6500. I basically have OSPF connection between the 2 devices but need to extend the same subnet across both devices. I don't have any more physical con...
I have the following setup in my environment today (please excuse any invalid network ranges as I changed them to not reflect exact IP's).router ospf 1 log-adjacency-changes area 185.224.96.0 range 10.0.64.0 255.255.224.0 area 185.224.96.0 range 185....
Ok here is what I did; but doesnt seem to function.switch 1config tint range g3/9 -13, g3/19channel-group 2 mode onint po2switchportswitchport trunk encapsulation dot1qswitchport mode trunkdescription Trunk connection for L2 Vlans to r2-Router switc...
I recently was givent he responsibility of a pair of PIX 515 which are running 6.3 software. I unfortunately needed to attempt a password recovery this morning and got an unexpected result.During the recovery process I was prompted to see if I wanted...
only problem is this ..The L3 tunneling encapsulation depends on the device that does the tunneling:Cisco 7301 supports L2TPv3 encapsulation.Cisco 65xx does not support L2 extension with the L2TPv3 tunnel. However, the L2 can be extended across an ML...
Alessio, thank you for the feedback, Your comments are right on track for what I want to accomplish, easier to read the ospf and troubleshoot. I had forgot to include any loopback but intended to have that listed as you stated.The redistribut static ...
I cant currently because this was a change i implemnted last night and it failed so I had to remove configs.When I looked at switch 1 everything was up and fine..when I looked at switch 2 nothing was up ..no po2 interface nor the physical interfaces...
