Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to set up a monitor session on a cisco 2960 and everytime I put the config in place, the destination port goes into UP/DOWN status. Once I remove the command, the interface comes right up. Any advice is most appreciated.
I have a Cisco 7206VXR router running BGP. Currently the CPU processes "IP RIB Update" and "BGP Router" are constantly spiking to 100% and then dropping again. It does this non stop. Can someone please give me some guidance on why this may be the ...
I'm having an issue where voicemails that are received by my users only displays the called party's number ie."Message from an unidentified caller (6135555211)". I want to set it up so that the name of the called party is displayed in the message. ...
I have a VPN tunnel set up at a remote satellite office which can reach systems in our HQ, however, we cannot talk to any systems at the remote office. The tunnel is configured using a dialer interface. i'm guessing the issue is that our inbound tr...
My VoIP implementation does not display the name of the calling party. The number is displayed, however, the name says "From Unknown Caller". I have validated with the carrier that our PRI circuits are configured to send through this information. ...
the name does appear on the IP phone display, however, that same name is not in the message field of the e:mail in my inbox that contains the voicemessage that was left. Instead the message field simply states "Message from an unidentified caller (4...
thank you very much for the info. I made the change and reset the gateway, however I still can't see the calling party name. I get the number but not the name. Any thoughts on what else could be the issue?
Gateway protocol is MGCP. here's some of the debug isdn q931:Feb 7 2008 12:26:27.406 EST: ISDN Se1/0:23 Q931: TX -> DISCONNECT pd = 8 callref = 0x9E4F Cause i = 0x8090 - Normal call clearingFeb 7 2008 12:26:27.566 EST: ISDN Se1/0:23 Q931: ...
