I almost forget that you need to add on localgateway the command "ip domain lookup" and if for any reason you have in localgateway the command "no ip domain look up" please remove it as your router will never attemp to do any name resolution.
Hi Saifuddin.miyaji.
Base on your debug outputs , what I can see is an error message regarding dns resolucion problemens:
Jan 10 08:02:45.407: //1386/000000000000/SIP/Error/act_register_dns_resolved:
resolve_sig_ip_address_to_bind failed
Please che...
Hi,
Do the following:
1.After powering UCS server please enter to the BIOS and press F8 in order to load CIMC options.
2. Within CIMC options please press F1 in order to load Additional settings(please see attached image)
3.then you will find the...
Hi Aaron, Please try changing the VTP mode to transparent on Cat3850, create new vlan and then switch it back to VTP server mode and let´s see what happens. Check if you are using vtp version 2, because if you are using vtp version 2 your swtich wil ...
Hi Markus,I´m hitting the same problem. We just deployed fifty 9200 switches that replaced lots of 2960´s.2960 switches were working fine and all its interfaces were forced to duplex full and speed 100 and there was any issue.BUT immediately after we...