HI ,I want to know what is the best position as Provider Edge for MPLS network ASR1002 or ASR903,what we need to be supported is VPLS ,Atom ,TE,multicast.? please advise
Hi, please what is the difference between the ASR1002 XE ios and the 7206VXR IOS?is the commands same for both IOS ?and is all the feature for 7206VXR IOS available in ASR1002 XE ios?
hi ,we have the below MPLS setup ,7206vxr are the PE's and 12406 is the core (P) (7206VXR) ------POS-OC3--------(GSR 12406)---------GE---------(7206VXR)we are trying to do test RFC2544 with 50Mbps throughput between the two PE's ,BUT always fail wit...
hi ,can we configure VLAN on the built in GE in ASR1002 and ASR1001 ,Can have subinterfacees on the built in GE interfaces and also configure Dot.1q for each customer with VRF on the subunterface,? also can we configure Xconnect for each customer on ...
the setup is correct, do you think sharing with other provider the loopback ip address is not a risk, and also the ASBR ip address we are peer with is from the globa routing in ASBR not from vrf
q1) is 12000 support dual stack ,and what will be impact if we will configure new stack ipv6,i do not think there will be any interact between the v4 and v6 here,q2) also how much do you think the load or cpu utilization when i added the ipv6 on the ...
Hi so what is the modules not support ipv6 bellow also the fwmw will run in transparent mode is there any impact here or limitation. Also what about the IPS
