Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,How can i make an etherchannel to be backup for another one? what does the "switchport backup" from "interface port-channel" command do?Also, there is a posibility to make an etherchannel with giga and fast ethernet interfaces?Thanks and rega...
Hi,As per NTP standard, the time on my devices should be synchronized with the local NTP server. I have 2 internal NTP servers. Unfortunately I am not able to synchronize my devices with those servers. The NTP updates are received but devices are not...
Hello,I'm using SDM to configure routers.It works just fine till I close the connection,reconfigure the network(ips,routing protocol etc)...and then...I can't use https to reconfigure it by SDM...it's a certificate problem..has anyone know smth about...
Hi,I have a router with 2 ethernet and 2 serial interfaces.I want to change my WAN link dynamically when the bandwidth is too low(the traffic will exit the LAN through the other serial interface).Thanks!
Hello!I have a question! 3 different ISP's are connected with a router! 2 of them are used for data traffic and the other one for the voice traffic.Behind the router I have 2 IP classes:one generates data traffic and the other voice traffic.The rou...
and if i'm using 2 default routes with different metrics i supposed the single case when the second route will be in the routing table is when the first goes down...and that's not what i want...i want to switch links only if the first one i'm using ...
