Hi All,I have a requirement where we need at least 8 to a maximum of 24 E1 terminating on a gateway and send the calls out/in via IP after.Is there a gateway that would support these number of E1's?The product I was looking at was a 7200 but I cannot...

Hi Gurus,Is there any method yet to route outgoing calls based on calling number on a gateway apart from blocking incoming calls based on the calling number?Thanks Shad

Hi All,I have come across a situation where another equipment is being replaced with a Cisco 2821 router with VWIC2-1MFT-T1 card. The previous equipment is configured to receive voice calls on first 10 channels but sends back any voice calls only on ...

Hi All,I have a 3745 configurad as an IP to IP gateway. I have a SIP trunk with G711ulaw to a Call Manager(5). There is another SIP trunk with GSM codec configured to another device. I can see that the transcoding does not kick in between G711 and G...

Hi All,As we know the 3750 is MLS capable. However I have not been able to find out that when doing inter-vlan routing, does it do it at hardware level after determining the flow or does it do it using the software based method as a router would do? ...