Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to know if the following command, when applied on a router, will affect all its local routes and redistributed routes or its local routes only:Does offset-list 0 out 5 fa0/0 affect only routes in the local routing table or routes ...
When i connect by console to the l2 switch i can ping all other switches, but from the pc i can not.From the l3 switches i can not ping the L2 switches.Please excuse for creating many threads.Thanks.
Dear All,After searching through the forum i could not find a solution and is obliged to ask for help.I have a cisco ASA 5510 connected to a cisco 3560 switch which has vlans (see configs).I want to access the servers in the dmz from each of the vlan...
Dear All,I have an issue with PBR.I have one catalyst 3560 on which i created vlan 100 (server vlan svi 172.31.0.120).Other vlans are users vlans.Users need to access the servers in their vlans,but at the same timeactive directory servers replication...
Dear All,I have installed a cisco nac solution in inband virtual gateway and setup active directory sso.I also configured mapping rules based on attributes from the active directory ldap server and it is workingI have several organisationnal units (c...
I wanted to say telnet.When i connect by console to the l2 switch i can telnet to all other switches, but from the pc i can not.From the l3 switches i can not telnet to the L2 switches.Please excuse for creating many threads.Thanks.
The WINS/DNS server is on the inside interface (in the server vlan behind the 192.168.104.0 network)For AD replication to work with other partners, the servers in the server vlan are having the ip address of the ISA server as their default gateway, n...
Thanks a lot.I can now access the serversin dmz by address only.When accessing by name, it does not work.The server url name is mtp:8081/helpdesk.Is there any way to configure this on ASA ?Thanks.
Dear Sir,Thanks for the reply.Option 2 is what is being done now. But with that option PBR on Server VLAN SVI does not selectively sends traffic to ISA server.Some times it does but after a few minutes it sends the traffic do the default ...
