Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am just about finished designing a QOS solution and have one query with regards to the following command srr-queue bandwidth shape 30 0 0 0I am happy with what this command does and how the weights work.I know the first weight is 1/30 of the inte...
HiThe background:Have peered (BGP) two of my internal routers through my firewalls to our main extranet provider (at two different sites within my network). The aim is to move to a more dynamic routing setup to incorporate a DR/BC approach (availabil...
HiI hve an old version of Ciscoworks and we are in the process of virtualising our server farms. Can my version (2.2) work in a virtualised environment?I also have solarwinds engineers edition on this box too just to complicate things further.any hel...
Hi I am in the process of having a seperate link (IP) installed between two of my Data Centre sites. The SAN is in one of them and I will be extending it (via FCIP) to the other once this big link is ready. There will be a combination of SAN traffic ...
HiI am in the process of having a seperate link (IP) installed between two of my Data Centre sites. The SAN is in one of them and I will be extending it (via FCIP) to the other once this big link is ready.There will be a combination of SAN traffic an...
Hi MichaelI'm using a couple of 3560-48TS switches running IPSERVICES.I've found out that the bandwidth statement will be ignored for what I was trying to do.The shape command will do its calculation on the physical interface so I've adjusted my wei...
HiI already submitted this question on the LAN switching board before I noticed your thread. I have re-submitted it here as I may hit the QOS "jackpot" for knowledge I have a query about the following commandsrr-queue bandwidth shape 30 0 0 0I unders...
Hi Giuseppefirstly thankyou for your time on this matter.I will try the summary-address first (never thought of that one). I take it this will stop the 700+ routes flying around my network and be restricted to my initial redistribution router.I did c...
Hithe link below give you the information you will need to configure a back-to-back link through the DSL ports. hope this helpshttp://www.cisco.com/en/US/tech/tk175/tk274/technologies_configuration_example09186a0080135834.shtml
