Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an FWSM in routed mode with 31 contexts and appear to be hitting a limit with VLAN interfaces (I've counted up and have around 115). If I add an interface to a context then name it with "nameif" the context stops passing traffic, removing with...
Have a very strange problem with a 2821 installation and wonder if anyone has seen this or something similar before?The original symptom was when configuring an IP address on a LAN port sub-interface, BGP would flap on the WAN. Since then all hardwar...
Wrote a TCL script to save the output from a show command into flash every 1 min (so I could monitor the noise on an ADSL connection). I open the file with an "a" for append option, write the output, then close. Tested on a 2811 and worked a treat wi...
Wrote a TCL script to save the output from a show command into flash every 1 min (so I could monitor the noise on an ADSL connection). I open the file with an "a" for append option, write the output, then close. Tested on a 2811 and worked a treat wi...
With telnet, you can get to another device by simply entering the destination IP address without prefixing with the command "telnet". As we are in the process of disabling telnet and replacing with SSHv2, is there any way of allowing ssh connections ...
Jouni,Thanks for reply - can't copy output direct, but we are running 3.1(21) with a license for 50 contexts and Max Interfaces is 1000, so nowhere near limit.We have 31 "inside" interfaces to match the 31 contexts but these are not shared and use t...
I am posting same reply I have put on another thread with similar issue, as no solution has been given..OK, the biggest clue is if you do a "show crypto ipsec sa" and this will list all tunnels you have configured. You should notice that there is a e...
I was having the same issue and when I found this thread thought great lets look at the solution - but the solution hasn't been given so had to work through myself and found out why it wasn't working for me. Hopefully my answer will help others havi...
Mohamed, many thanks for your response, but just found out a colleague had already posted the same query earlier on today under "2821 - Serial/BGP Flaps when LAN connected" so could I ask if you have any further suggestions to please respond to this...
Apologies to all (especially to Mohamed who replied) but I have just found out my colleague John has already posted a question on this problem earlier today under "2821 - Serial/BGP Flaps when LAN connected".As you can probably tell we are both total...
