Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Scenario: extend multiple layer 2 vlans to multiple locations (at least 3) over IPSEC. I used L2TPv3 to accomplish this goal for a single vlan. The solution works great, but I’ve been given a new requirement to extend multiple vlans over the same p...
Good morning,I am seeking advice regarding firewall capabilities between internal VLANs. I currently have a collapsed core architecture with a single core switch (4500 series). All internal VLAN SVIs reside on the core switch. I'm using access lis...
The Monitor -> Dashboards -> Monitoring screen is telling me that there is no performance or availability data because there are no configured pollers. When I look at the pollers configuration, I don't have a create button, nor can I edit any of the...
Is user tracking able to function without SNMPv2? I recently implemented SNMPv3 on a couple of Cisco 3750's to test LMS functionality. Since I removed SNMPv2 from these switches, I no longer get IP and MAC address information in user tracking repor...
I am having trouble with the SNMP v3 context configuration. I can't get SNMP v3 configured to use context prefix matching.SNMP v3 Group that works:snmp-server group v3lms v3 priv read v1default write v1default access 10snmp-server group v3lms v3 aut...
David, this is the same problem I am currently facing. With multipoint L2TPv3, you need to provision additional interfaces, on the LAN side of the router, to create the xconnect mesh between all destinations. R1 (E0/0) ------xconnect to------ R2 Loo...
I'm not having any luck implementing the SNMP context. I'm getting the MAC and port vlan assigment in LMS, but I'm not getting the IP address.snmp-server group v3lms v3 auth read v1default write v1default access 10snmp-server group v3lms v3 priv rea...
Stephen,Thanks for the reply.The download for LMS 3.2 fails on the download page. I can't find the 3.2 software on the Cisco download page either. Is the 3.2.1 download just a patch or can I upgrade from 3.0 to 3.2.1?
Mr. Clarke,The help section on the Dynamic User Tracking page shows the following commands as necessary to enable the SNMP traps.mac-address-table notification interval 15Is CiscoWorks smart enough to deploy the correct commands for each IOS version ...
