Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue that someone may be able to help with.We have a solution that uses a Cisco router to connect via 2 seperate PVC's to different locations for resilience. We use EIGRP and bandwidth statements to define which PVC to use as the primary.W...
Does anybody know the pin-outs to make a cable so that I can connect a port on a NM-8A/S (DB60)to the console port on a 2950 switch. This is for out of band management.Any help would be great.
Any help would be appreciated. We are trying to link two buildings using wireless. This is not a problem. However we also need some form of backup. The idea is to use ISDN as a backup. The scenario would be that the wireless was plugged into one ethe...
I have a 3DES VPN tunnel running between a 3640 and a 2600 router. I am looking to install VPN modlues in each router to increase the throughput.Do these modules require any additional configuration in the router?
Does anybody know for certain what is the recommended maximum number of IPX hosts per VLAN and where the official documentaion exists eg. an RFCThanks in advanceWill
There is not a dynamic way to assign a specific mask. The only way would be to assign static addressess to clients. If you are worried about the routing of a particular subnet then you could use a subnet which as a default has the mask you require. T...
The reason you are assigned a netmask from the concentrator is that it treats it the same as PPP. The default for this is to issue the default mask for the subnet class. For example 10.0.0.1 will always have the mask 255.0.0.0 and 192.168.0.1 will ha...
If you are still wondering about this. Are you using post-dial terminal window for the dial-in users? There is no interaction between MS DUN and the RAS box as far as this is concerned. The reason it works with VPN 3000 is the client presents the cha...
