OK Mikey Boy. I schedule another visit to the client for this Monday 28 and I will take the "show" that you ask me. Thank you very much again for the support. ... View more

 Mikey Boy: thanks for your answer. We did that. But the AP SSO is never synchronized. We follow the step-by-step document.   Under what scenarios could the configuration fail? ... View more

 Mikey Boy: thanks for your answer. We did that. But the AP SSO is never synchronized. We follow the step-by-step document.   Under what scenarios could the configuration fail?   ... View more

Hi,  Review the attached image. It can be useful. ... View more

I have the same issue. Any update about this?...is Phy issue or what? ... View more

Thank you, I had already read it. And I also read these other two links: https://mrncciew.com/2013/03/17/ap-registration/ http://what-when-how.com/deploying-and-troubleshooting-cisco-wireless-lan-controllers/capwap-communication-control-and-data-encryption-cisco-wireless-lan-controllers/ in those links, the authors talk about the command: "test capwap encr APNAME", and that is why I consult if there is an equivalent command in version 8.6 or 8.5... ... View more

Thanks for your reply. The Data Encryption Checkbox involve the Control CAPWAP message? Capwap Data + Capwap Ctrl message? ... View more

Hi,   How to disabled DTLS Control Packets encryption on WLC release 8.6.101.0 or 8.5.120.0 for troubleshooting purposes. ... View more

Hi Flavio Miranda. Thanks for your answer. A question for you: We have three WLC 5520: -2 WLC in the North (AP-Client - SSO HA). -1 WLC in the South (N+1 HA with the WLC_North). Both side attache to VSS switch. For each zone, we have one team with four (4) technical specialists to assist end-users to resolve wireless connectivity issues. So, the question is: ¿How many active session (HTTPS and/or CLI) can support a WLC 5520? About your suggestion: We run the suggested command (config network web-auth https-redirect disable) only in WLC_South for testing purposes and right now we are waiting for the final report of the South Team about the GUI access. ... View more

Great discovery Maxim ... Why Patoberli talk about a bad configuration?? ... View more

Hi,   I'm worried about your answer. Look, we configure our WLC 5520 based on this document: In section "AP and Client SSO" https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-1/5520-WLC-DG/b_Cisco-5520-WLC-deployment-guide.html   My topology attached below.     ... View more

Thanks, Flavio. The mesh AP with the clients count has the radio slot 0 actives (2.4GHz). So that was why to appear in the statistics. We finally disable radio slot 0 and no more client appear in the mesh tree. Thanks again for your support. ... View more

Thanks for your help. Attached output file. ... View more