Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to upgrade a AIR-CT5508-25-K9 WLC from 8.0.133.0 to the latest version and running into the following error: Message Log Severity Level ...................... VERBOSE*ipv6SocketTask: May 10 21:27:06.425: %SOCKET_TASK-7-DATA_PROCESSING_FAIL...
I'm trying to provision an 1852i running ME version 8.5.105.0. I went through the installation wizard to setup the management addresses with no issue.I'm in the CLI via console as well as the CLI via SSH, and can access the GUI, but any attempt at tr...
I'm trying to setup a GRE tunnel between two routers, where one router (DC) is having an ASA do the encryption and the encryption on the end is being done in the router itself. Each router has loopbacks to be encrypted so that they be used as the en...
Looking at a previous thread the question was never really answered. I'm trying to setup MAC filtering on a Cisco c1111 router and apply it to the WAN sub-interface - not on the embedded switch ports. My question is how to apply the extended MAC acce...
I'm having two issues. I first tried upgrading the IOS from 12.2(31)SG to 15.0(2)SG11. I get the image on both active and standby SUP engines, verify that the checksums match with Cisco and proceed to reboot the redundant peer. Looking at the bootu...
Leo, you're absolutely right. I had a brain freeze for a moment and was looking at images for the 3500 controllers. I'll get to downloading the proper images and work on getting that uploaded. I don't know what I was thinking.
Here is a debug from the router doing the encryption Apr 8 21:41:56.479: IKEv2:% Getting preshared key from profile keyring keyring-VPN-B2B-To-DCApr 8 21:41:56.479: IKEv2:% Matched peer block 'B2B-DC'Apr 8 21:41:56.479: IKEv2:Searching Policy with fv...
The outside interface is configured with the crypto map. We can't use the public addresses as the source/destination on the router/firewall design. There is no public address on the DC edge router, hence the need for using loopback addresses.I've do...
