About SuhaibElziq

SuhaibElziq · 11-14-2021

Hello guys, We face policy update failed with error code 3240099844, I found a bug matching this error (CSCvh57752). It seems that the workaround mentioned the bug document wrong or I did not really get it. Workaround: To avoid this happening make su...

SuhaibElziq · 12-09-2019

Hi,A customer purchased Cisco C9200L switches with both C9200L Network Essential & C9200L Cisco DNA Essentials. Both lic. are showing EVAL Mode when he checked them against "show lic summary", and they are already under production.Some of these swit...

SuhaibElziq · 02-02-2018

Dears, We have installed RPS 2300 devices on our Data Center during the maintenance window we have connected different devices to the RPSs. Everything is working, and we were able to check the connected RPSs using "show inventory" command. After ...

SuhaibElziq · 08-16-2017

Dear, We have a setup of C6800 VSS cores with C6880 ia FEX switches, 2 days ago one of the the uplinks connected from Fex to VSS core became on err-disabled state from the Fex side. So how can I access the Fex tengig interfaces ? And is there any...

SuhaibElziq · 08-01-2017

Dears, I need a little help, does the entries shown under Displaying entries from active supervisor section means that this is the alternative path for the traffic ?? VSS_Core#sh mac address-table address e41f.136b.89c8 Legend...

SuhaibElziq · 02-14-2018

I have been reading about such cosmetic bugs, and updating the device to a newer version may and may not solve such behavior. The only advise I found is to reload the boxes, but it is not a reasonable solution.

SuhaibElziq · 05-11-2017

Hello a.alekseev I have actually tested the below two day ago, but I got the same issue: access-list 101 deny ip 192.168.7.0 0.0.0.255 host 192.168.7.1access-list 101 permit ip 192.168.7.0 0.0.0.255 any But the above scenario that you have suggeste...

SuhaibElziq · 05-09-2017

Yes that is right that the route map is forcing the traffic to the firewall, but on the other side of this the workstations and the gateway are in the same subnet so I should be able to access them without the need for the routes! And also this shou...

SuhaibElziq · 05-09-2017

Hi, It is strange, and yes I have tried to disconnect the FEXs still the same issue. An RMA ticket has been created. Thanks

SuhaibElziq · 05-04-2017

Hi, It seems that they are not booting at all, and I am unable to access the devices by console. I am planning to do that, but its so weird that both of them failed with the same problem. Is it a common thing with this model? Thanks

Member Since	‎03-18-2017 11:21 PM
Date Last Visited	‎11-17-2021 12:48 AM
Posts	12

User Statistics

User Activity

AMP VPC policy update failed err 3240099844

C9200L Cisco DNA Essentials Activation

RPS 2300 is Not Showing in 2911 Routers "show inventory"

FEX Uplinks in errdisable state

sh mac address-table address on VSS Cores

Re: RPS 2300 is Not Showing in 2911 Routers "show inventory"

I have actually tested the

Yes it seems that the route

Hi,

Hi,