Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have been experiencing some issues with Jabber for Windows version 11.5 and I hope someone can throw some light.
I am currently running CUCM version 9.1.2 in a cluster 1:1 and I am trying to deploy Jabber for Windows 11.5 in phone-only mode. I ...
Hi all,I have a 1006 ASR and I need to apply 2 different QoS policies to 2 different subinterfaces.I have created a parent policy and the policy that I want to apply inside, in order to apply it on the subinterface and that is working fine but the pr...
Hi,Hope someone could give me a hand on this. I have a Cisco 2901 with IOS version c2900-universalk9-mz.SPA.152-4.M3.bin and I want to install and configure a VIC2 - BRI-NT/TE card on it. The card is already inserted and I can see it when I do "sh di...
Hi all,I have a 2 Cisco 3750X stacked working as CORE switches but not in production yet showing a high CPU utilization and I would like to see with you whether you think this is normal or a IOS upgrade/downgrade should be performed.I have very low t...
Hi all,Hope you can help me out to try to automate the backup in the following scenario:The main circuit is a 10Mb MPLS link with my ISP propagating my routes using eBGP and as a temporal solution, I'd like to implement a site2site link through a DSL...
Hi,
The solution was to modify the xml file. I read this in a different post but I guess I had few other parameters that were also interfering. So this would be the file that works good for my Jabber for Windows.
I have added the BDI section to test ...
Thanks,I could activate the evaluation license with following command:conf tlicense boot module c2900 technology-package uck9reloadNow I will wait for my final license.Thank you!
