Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a cluster/site of 150AX and 151AXM. I need to upgrade the firmware to add new devices. However, no matter what I do, I get:Invalid tarfile or extractionI have tried to remove one mesh extender to check that it was not corrupt, but then the e...
Hi,I have a newly setup network of AP 150AX and Mesh 151AXM. The mesh AP's seem not to get connected even though the app says they are connected.The mesh AP's will flash blue for days. How do I troubleshoot these AP's?Thanks.
Hi,I have set CBW150AX by using the Cisco Business iOS app. That works fine. However I would like the possibility of monitoring and configuring by web interface but whenever I try to connect to the unit it times out.Why is it not possible to access t...
Hi, I have a SG110 switch. Suddenly after a power down the switch is not supplying any POE consumers. Is there anything to try to make it work again? The link LED is lit but not the POE and there is no power at the consumer. Thanks.
Hi, I have two WAP150's in a cluster. I want the AP's to run PoE. I have Ubiquiti 24W injectors, however the AP's do not start. Is there some kind of settings I can change or check to see what is the cause of this? Thanks a lot.
Thanks, KJK99. No, I did not try another browser. I will do that when I get the chance. I agree to update as adviced by Cisco. I have another CBW150AX with the 10.7.2.0 firmware, so I was thinking to factory reset the mesh extenders and have them upd...
Thanks. Thanks a lot.I have been wondering about doing that. However, the original issue was that it was impossible to connect a new AP with firmware 10.7.2.0 to the current cluster of 10.5.2.0. If I do what you describe, I am afraid that the same wi...
It works when updating the mesh-AP's separately.https://www.cisco.com/c/en/us/support/docs/smb/wireless/CB-Wireless-Mesh/2063-Upgrade-software-of-CBW-access-point.html
So, I managed to upload the firmware manually from the maintenance software update setting. I hope it works now. I will validate with the other 151's I have.
