About gomsi1982

gomsi1982 · ‎07-11-2016

Hi, I'm kinda confused with this requirement where I have Cisco 2951 Router with 2 MFT T1/E1 card. Router is getting E1 from PSTN which is fine. I need to connect other E1 port to Aria PBX for integrating PBX with IP Telephony but the issue is the PBX can't do QSIG and can do E1 only. my question is how can I configure router to emulate as PSTN for PBX so I can route calls between pbx and pstn. Thanks Gautam

gomsi1982 · 07-11-2016

Hi, I'm kinda confused with this requirement where I have Cisco 2951 Router with 2 MFT T1/E1 card. R...

gomsi1982 · 03-12-2013

Hi All,we have two IP IVR server not in replication..they both are configured for redundancy but som...

gomsi1982 · 10-23-2012

Hi,I need someone's help as I got a job to update existing devices with CFUR destinations and CSS wi...

gomsi1982 · 09-20-2012

Hi,I have got two IP IVR Servers one with 150 ports and another with 6 ports in Active/Backup style....

gomsi1982 · 09-06-2012

Hi, I'm going to change the IP addresses of ADs integrated with our CUCM and all forests and credent...

gomsi1982 · 08-10-2012

Hi All,I'm a new user on this forum and would like to put my confusion to get some solution,I have a...

Date Registered	‎07-30-2007 01:11 PM
Date Last Visited	‎07-11-2018 12:38 AM
Total Messages Posted	6

Configure Cisco Router as PSTN E1 emula...

Configure Cisco Router as PSTN E1 emulator for Aria PBX

IP IVR Prompts folder - copy to anotehr IP IVR possible?

BAT update for adding CFUR Destination and CSS

How to Monitor CTI Ports in CUCM

How to verify CUCM and AD Sync and Auth successful

LDAP Server IP change Impact on UC network