Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ok hopefully not to dumb a question. I read somewhere in the ordering guide for the 1230 that you need to order two antennae in addition to the base access point or access point/radio bundleIs that true for all antenna types or just the typical dipo...
Hi,my customer has a cisco 831 using road runner cable based broadband. He uses freeworlddialup external VOIP provider using an ata186 device. There is only one VOIP device in his small network. This is a SIP based service.I would like to give hi...
Hi,I have a customer using an ATA186 behind a linksys broadband router doing NAT. He gets one dynamic address from his cable internet provider (roadrunner).I know there are issues using SIP in a NAT environment. The customer wants to replace his li...
Hi y'allI'm trying to figure out the differences between the 827 and 827H. So far I understand the 827H has 4 10baseT ports, and comes standard with 32mb DRAM instead of 16mb. What else? Does the 827H come standard with IP/FW?ThanksJohn
Hi folks, I have an issue with the ftp fixup feature on passive ftp. The PIX 515 (6.1) has private addresses on the inside and outside. NAT for all the lan clients is done not by the PIX but by the edge router (a 2620). LAN = PIX = 2620 = internet I ...
Hi,Are you behind a router performing NAT? Is the voice gateway on the other side of the router? I believe this setup delineates the issues I am trying to address, but glad to hear that the router works well with SIP phones.ThanksJohnjohn.jamison@w...
I have configured a 2620 with a DSL WAN card for use with PacBell Enhanced DSL service (5 static IPs)I believe you are missing the IRB setup (integrated routing & bridging)Here are the relevant config lines as I recallbridge irbinterface ATM0/0 no ...
when the vpn client gets disconnected, is the machine situated on another network behind a firewall, or directly connected to an ISP?When you say you get a dhcp address while on the inside, are you saying you can successfully connect using the VPN cl...
First of all I think the killer is that the pix can only have one default route. Thus while your pix will receive traffic on any of 3 interfaces, the traffic back will take one and only one path, which probably won't work. You have to consider the ...
It is the behavior of thefixup protocol smtp 25command to rewrite the SMTP responses. The 220 message is a response to the initial socket connection opening. The fixup command rewrites the text component of the response with asterisk so to hide pote...
