Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Fellas,We bought Cisco Prime Infrastructure 1.2 appliance. The application seems to be pre-installed. I have gone through setup process. But I cannot connect/open web interface(https://PI-ip-address). What could be the problem ?
Hello Fellas.Is it possible to carry FabricPath vlan on 802.1q Trunk link on N7k ? If I would configure one interface in Fabricpath mode, other one in Trunk. Will I be able to forward traffic between this two ports? vlan 10 mode FabricPath!!Interface...
Hello to everyone!Why my asa5520 brings out:sh curpriv Username : enable_15Current privilege level : 15Current Mode/s : P_PRIVwhile i am logging in with my username which is XXXX. And in my ACS accounting logs I cannot see which user did what.thanks ...
Hi people.I recently faced an issue at work. Clients want to make ipsec site-to-site vpn redundant. I have 2-asa-5520 working in a stack. Is it possible to configure site-to-site vpn in a redundant mode, like first peer ip address is x.x.x.x and sec...
I have stopped and started the system. The result is the same. "show logging system tail" doesn't give much information. How can I reset the appliance ?
Here is the output: ncs statusHealth Monitor is running, with an error.failed to start NCS on startup Health MonitorReporting Server is runningFtp Server is runningDatabase server is runningTftp Server is runningMatlab Server is runningNMS Server is...
Yes, I can login via ssh to the server. It is not a virtual apliance. I can login to Helth monitor interface which is on port 8082. But https connection doesn't work. When I check listening ports on server I cannot find https-443 port on that list: ...
