Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have an ISE deployment where we are looking to use EAP-FAST as our authentication method with EAP-TLS as the inner method. We are checking both machine and user certificate. We initally had the following condition in our AuthZ rule -> EapChainingR...
We currently have a QoS policy as per configuration below:!!policy-map QOS_POLICYclass VOICE set dscp ef police cir 12800 bc 8000 conform-action transmit exceed-action drop!!I wanted to increase the CIR, the BC and also change the exceed a...
Had a question regarding OSPF fast hello. Lets say i configure fast hello on an interface using the command:ip ospf dead-interval minimal hello-multiplier 5This means my dead interval is 1 second (this value never changes)This also means 5 hellos are...
Noticed on one of our routers that there are routes in the database but no RIP routes in the routing table. Routing is also running BGP. Not sure I understand why this is occuring. Output below:RouterA#sh ip rip database0.0.0.0/0 auto-summary0.0.0...
Hi,I am currently trying to find a book or video mentor series to familiarise myself with the ACE module a bit more. I know there is an exam that revolves around the product (642-975 DCASI) but i cant find any cisco press books and it seems the only ...
@otwilliamsI was also in the same boat as you but as per Marvin Rhoad's suggestion i did a clean install with 3.1 instead of messing around with multiple updates. So far no issues and 3.1 has been running well so if a clean install is feasible for yo...
@marvin.rhoadsThanks, i will give that a try. I will go for a clean install with 3.1 as a lot of my experience of upgrading with prime infrastructure or prime LMS over the years has been very painful.
Hi Govasrin,I have the exact same issue as the OP. Could you please make 3.0.2 available for download for me as well. I need TP 1.0.3 as this is the only patch that is compatible with our version of WLC's. Thanks in advance
Andy,Not sure if you still have this problem but we have a similar issue. As you know the ASA cannot generate a CSR with SAN attributes. The solution for us was to create a the CSR using OpenSSL and then get it signed and imported on to the ASA.
