Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello colleagues, the history - we had DMVPN configured on different models 800, 2800, 2900 series with different IOS versions. Everything works quite good. Recently we added two new routers - c1111-4p, with different IOS versions - 16.8.1 and 16.9.3...
Hello,
please, could someone help me to find information about if C9300-NM-8X card supports sfp or sfp+ only. So is it possible to use for 1gigabitethernet port. The only indirect prove that it's possible I found in the document
http://www.cisco.com...
but for the Bug ID you provided there is no any answer to the question when this support will be added or if it will be added at all. This bug was issued by mistake to the PSIRT, which is a completely wrong place, and the answer is exactly that it is...
yes, that's very strange. Catalyst 1000 series was a recommended replacement for Catalyst 2960-L series switches which were announced as end of life about 4 years ago. And still, 2960-L are supported in a Catalyst Center, but Catalyst 1000 is not. Bu...
forgot to add, I captured traffic from tunnel interface and it is clear that the spoke doesn't send the first packet to the hub, so it is not dropped on the hub of further.
