Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a customer currently running CCM 4.1. They have just purchased Unified Call Manager 5.0 appliance. Does anyone know if it is possible to use DMA to get the existing database off the CCM 4.1 server and to import it onto the new appliance? Any h...
I was wondering if anyone has experienced a problem whereby a 7985 resets during a video call. This happens intermittently. The 7985 drops the call, the LCD goes blank, the red LED is on for a few seconds then it comes back. It doesn't seem to go thr...
My customer has just upgraded from ACS 3.2 to 4.0 to resolve some problems and now have a big issue that wasn't there previously. It is a well-known problem: unable to roam with Windows XP and PEAP. I believe there is a Microsoft fix but this is not ...
I have a customer with Cat6500 and WLSM running WDS. The APs and dot1x clients can authenticate with the ACS server. However, we cannot get any accounting information. We have tried configuring the WLSM with the following commands:aaa accounting netw...
Hi Rob,Thanks for the advise, most helpful as always. We have also been discussing keeping both Unity servers. If however they would like to run with a single server, I will email Cisco Licensing, as suggested.Regards,Tracey
Hi Rob,Thanks for another very helpful posting!I was wondering if you can provide some advise on my scenario. I have two companies that are merging. Both have Cisco IPT solutions. The CCM and Unity servers belonging to the smaller company will no lon...
Just a quick update. I arrived at my customer's site to discover their existing call manager is on 3.2(3). I have been working on getting this up to 4.1(3) so I can use DMA. I ran the install wizard on the new server out of curiosity and then had a p...
Thanks Rob. I have not got off to a good start. I have an MCS-7835-I2. When I power it on, I get as far as "configuring kernel parameters [ok]" and no further. I was wondering if it was something to do with the mouse and keyboard. I have tried these ...
