There might be another feature I am missing, but essentially, this is what I am trying to accomplish:   I have a user that will be spending half the week in one office, and the other half in the other office. Both of these locations have their own CUCM 10.5, but they are connected and are under the same domain. Ideally, I would like for both the extensions to ring if someone calls either one. But maybe setup a group on one call manager and have both extension ring that way? I'm not sure if that would work though.   Any help would be greatly appreciated. Thanks! ... View more

Hey everyone,  So I saw a couple posts on this already, but I was unable to find something that pertained to a wireless phone.    We have a couple of Cisco 7925's still laying around, but one in particular is causing trouble. When I look at the logging on one of our access switches, I see this:   %SW_MATM-4-MACFLAP_NOTIF: Host 10f3.11xx.xxxx in vlan 30 is flapping between port Gi2/0/47 and port Gi1/0/47 One of those ports is to one of our WAPs and the other goes to our core switch. On another access switch, I am receiving the same issue. So it's my understanding that the phone is bouncing over to different access points.    I know that's not a big deal, but was curious if there is something I can do about the logging that's happening, or if I can improve on something that could prevent this.  ... View more

Hi everyone,   I'm fairly new to CUCM and was looking for some guidance. I recently inherited CUCM 10 and have gotten the basics down, but am still learning the rest.   There is an external 1(877) number (OpenVoice Conference Number), and is the only 877 number we cannot call. When we dial it, there is only silence and then the call automatically ends. I am able to call the number from my cell phone, so I know it's a working number. Here is the list of our call routes for 18XX numbers. As you can see, there are some routes that are made to refuse the call. I made a route that is specified for the number (See "Conference Call Number" in the picture), and am still not being put through. But when I dial other 877 numbers, I have no issue.   I tried to use DNA, and although I'm not entirely sure that I am putting the information in correctly, these were the results:   I've contacted our phone service provider and opened a ticket with them to make sure that the number isn't dropping on their end.   Any help would be greatly appreciated as I'm a little lost on what I could be doing to fix this. ... View more

Hi everyone,   I'm fairly new to CUCM and was looking for some guidance. I recently inherited CUCM 10 and have gotten the basics down, but am still learning the rest.   There is an external 1(877) number (OpenVoice Conference Number), and is the only 877 number we cannot call. When we dial it, there is only silence and then the call automatically ends. I am able to call the number from my cell phone, so I know it's a working number. Here is the list of our call routes for 18XX numbers. As you can see, there are some routes that are made to refuse the call. I made a route that is specified for the number (See "Conference Call Number" in the picture), and am still not being put through. But when I dial other 877 numbers, I have no issue.   I tried to use DNA, and although I'm not entirely sure that I am putting the information in correctly, these were the results:   I've contacted our phone service provider and opened a ticket with them to make sure that the number isn't dropping on their end.   Any help would be greatly appreciated as I'm a little lost on what I could be doing to fix this. ... View more