I have 2 new Cisco UCS C220 M3S running 2.0(3b) and 2.0(1b) connected to a UCS-FI6248UP 5.2(3)N2(2.23d) via a Intel X520-DA2. I also have both management interfaces up via a 100 meg copper connections. My issue is that I can't see these servers in ...
When you run the AD Test Connection tool it can up to a minute or two to return, is there a cli commnad to see what its looking for or looking at ?? Version 5.3.40.4
After setting up a Mobility Group the control channel appears to be up but the data path shows to be down so I know the two WLCs see each other. There are firewalls on each side of the WLCs the only issue that I have with that is at this point I cann...
I have the same issue, with 3 of my 5508 controllers; after reading afrahmad post I tried to oppisite since I use Lifecycle view as my default and have this issue. I changed the view to Classic and went to Configure>Controllers selected the first 55...
I understand, looking back I opened a TAC case and work with a couple of engineers and tried several things none of which worked, but what really got it to work was an old fashion reboot of the anchor controller, thats right after the reboot everythi...
Eping fails on from both WLCs, the mob look configuration looks good, I have some one looking into the acl issue Remote WLC (Cisco Controller) >mping 10.40.96.10Send count=3, Receive count=3 from 10.40.96.10(Cisco Controller) >eping 10.40.96.10Send c...
