I have a scenario wherein the user has connected an USB Hub ( Make : HP 3005 PR Port Replicator) to the IP Phone. The USB Hub has 2 ports of USB 2.02 Ports of USB 3.01 Ethernet cable to connect to the Network1 Headphone port 1 Micorphone port1 Displa...
Team, I am trying to make a modification of the agent Id in terms of providing the extension number to login. While doing the changes and save them, the values get reflected in UCCX. In this case, I am making an extension number change and...
Can PRI register with Natted IP using MGCP configuration ? I have a Voice gateway router on a firewall outside interface and my Call manager sits in DMZ and the IP Phones are inside interface of the Firewall.My Call Manager version is 6.1.2 and route...
Hi All, We have currently installed IP Phones ( 6921) inside the Firewall (FWSM) for one of the project. All communications between the Phones and those registered outside are working absolutely fine. Now we are having issues when the user (u...
Hi All, We have currently installed IP Phones ( 6921) inside the Firewall (FWSM) for one of the project. All communications between the Phones and those registered outside are working absolutely fine. Now we are having issues when the user (usi...
Thanks guys for the info.. I restarted the MOH Servers and the issue was resolved. Restarting did the trick. Once again thanks for your timely help !!!
Hi David, Yes I did check the Hardware Conf Bridge. All ave been registered with the CUCM. Also have added Media Resource Group. All these have been taken care off. Any alternate suggestions please ??
Thanks Hossain for the suggestion. But the setup was working until a week back until I replaced the Conf Bridge which was configured in 6608 E1 module. Had to replace the module for some reason after which I had configured a new one. After which this...
